Introduction to the selection of annealing and normalizing
Release time:
2022-03-22
Annealing and normalizing belong to the same type of heat treatment. In actual production, the selection of annealing and normalizing is mainly considered from the following three aspects.
Annealing and normalizing belong to the same type of heat treatment. In actual production, the selection of annealing and normalizing is mainly considered from the following three aspects.
1. From the perspective of machinability
The cutting performance of metals, including hardness, chip brittleness, machining surface roughness, and tool wear. Generally speaking, the hardness of metals ranges from 170-230HBW, indicating good cutting performance. If the hardness is too high, it is not only difficult to process, but also causes the tool to wear quickly; If the hardness is too low, it is easy to cause sticking and chip entanglement during cutting, reducing the tool life, and the cutting surface is rough. In general production, normalizing is more suitable as a preparatory heat treatment for low and medium carbon structural steel, while annealing (spheroidizing annealing) is preferred for high carbon structural steel (such as bearing steel) and tool steel. For alloy steel, due to the presence of alloying elements, the hardness of the steel increases. Therefore, in most cases, alloy steel with medium carbon or higher is often annealed.
2. From a performance perspective
If the performance requirements for steel parts are not too high, normalizing can be used as the final heat treatment. However, if the size or shape of the component is large or complex, normalizing may cause significant residual force or deformation or cracking of the component. In this case, annealing should be chosen, which requires high mechanical properties. The final heat treatment of the component must be carried out after quenching and tempering. In order to reduce the tendency of deformation and cracking, annealing should be used for preliminary heat treatment.
3. From an economic perspective
Normalizing has a shorter production cycle than annealing and is easy to operate. Under possible conditions, especially in mass production, priority should be given to normalizing instead of annealing.
Related News
Good news! Our company won the Changzhou Innovation and Entrepreneurship Competition!
What is homogenization annealing of metal heat treatment?
Types of annealing and normalizing heat treatment operations commonly used in bearing production
A simple understanding of the processing sequence of metal heat treatment